| Author |
 Replies: 16 / Views: 3,061 |
Page 2 of 2
|
|
|
|
Valued Member
United States
310 Posts |
Well, you may have missed out on searching them, he didn't lose out on any money scraping them, as it's illegal to melt copper pennies at the moment.
|
|
Valued Member
 United States
339 Posts |
ok, good, and also, I kept that '43 penny in some lemon juice for an hour and took it out and the back got a lot cleaner and it turned out to be a steel wheat that was just very very very dirty, ill try it again to get the front of the coin a bit cleaner because it still look a little bit like copper on the front
|
|
Valued Member
United States
339 Posts |
well, a simple magnet test concluded that the penny is a steel Wheat penny, nice find, I used to have a couple but I lost them years ago |
|
Valued Member
United States
218 Posts |
if its a 1943 there's no question in my mind that's it steel sounds like some nice finds though
|
|
Valued Member
United States
339 Posts |
yeah, not too bad considering I didnt have to go coin roll hunting or check my registers at work since I didnt have to work today, I'm thinking of going to a bank and buying a box of pennies, when you do that are you getting coins in circulation or would be getting a lot of mint rolls of shield cents?, id like to try my luck at finding more steels or wheats
|
|
Bedrock of the Community
United States
20753 Posts |
Stories like this remind me of a long time ago, at a place I worked, a co-worker told me his parents had been saving Dimes in a large bottle since he was born. It was supposed to be for a wedding present some day. He did get married and his parents took that jar to a bank, cashed it in, gave him the currency instead of the Dimes. There was over $1,200 in Dimes. And that was back in the 60's somewhere.  |
|
New Member
United States
35 Posts |
I started putting pocket change cents in a 5 gal glass Sparklets bottle in 1978 and filled it in 1994. Back then I payed cash for everything so always had plenty of change. Had to use the ketchup bottle trick to get them out (butterknife).Whew!
I stowed them away in sealed liquor tins and maybe one of these days............
|
|
Valued Member
United States
339 Posts |
most of those dimes were probably silver too, I wonder what kind of coins today we think are only worth face value but in the future be like silver coins and be worth a lot more, I see that copper pennies are doing the same
|
|
New Member
United States
29 Posts |
Quote:
ok, good, and also, I kept that '43 penny in some lemon juice for an hour and took it out and the back got a lot cleaner and it turned out to be a steel wheat that was just very very very dirty, ill try it again to get the front of the coin a bit cleaner because it still look a little bit like copper on the front
NO, please dont use lemon juice you will destroy the penny, I've succesfully cleaned coins using the method described in this guide http://reviews.ebay.com/Cleaning-co...000001263322 |
|
Bedrock of the Community
United States
17884 Posts |
Maverick, the 43 was already heavily corroded when he started, it was already destroyed. He really couldn't hurt it and in this case may have actually helped it. After all which would you rather have a lump of iron oxide, or a cleaned but identifiable steel cent?
|
|
Pillar of the Community
Australia
4411 Posts |
Quote:
 I want to share a few bits of information that I got from some good sources in the field of cleaning coins. You should start with some necessary tools.
1. Brushes: a toothbrush, a plastic or fiber glass brush. A brass brush works the best.
2. Detail tools. Either a toothpick or a soft metal pick for cleaning between letters etc.
3. Cotton swabs for cleaning slightly dirty coins
4. containers for your solvents etc.
5. A good light is always nice Above is a quote from that cleaning advice maverick. "A brass brush works the best"    Skimming over it and seeing this was enough for me to discredit his entire opinion. |
|
Bedrock of the Community
United States
20753 Posts |
Quote:
1. Brushes: a toothbrush, a plastic or fiber glass brush. A brass brush works the best.
2. Detail tools. Either a toothpick or a soft metal pick for cleaning between letters etc.
3. Cotton swabs for cleaning slightly dirty coins
4. containers for your solvents etc.
5. A good light is always nice
Nice list. I would like to add 6. Bench grinder with fine wheel 7. Butane torches to get tar off coins 8. NitroGlycerine to blow dirt off coins 9. A piece of Radium to sanitize coins from handling. 10. And always use that drop method to tell what coins are made of. And must be done from a minimum of a 10 story building. Please don't take this serious. There are enough idiots posting methods of cleaning coins. I've always wondered if anyone posts somewhere on how to clean Egyptian Mummies.   |
|
Bedrock of the Community
13014 Posts |
Quote:
Above is a quote from that cleaning advice maverick. "A brass brush works the best" Well technically he is right, brass brushes do a great job of getting the dirt off  Carl you forgot 11. a good sander to remove rust. 12. A nice polish at the end After all you want it looking its best |
|
Pillar of the Community
Australia
4411 Posts |
Whilst at it why not melt the coin completely and cast a fresh one
|
|
Valued Member
United States
339 Posts |
yeah, the coin was very heavily corroded and also dirty (or just corroded) to the point that it looked copper, I wish I got before and after pictures but I didnt but you can clearly see the date and tell by looking at it that its a steel penny. just lemon juice and a sock worked, ill put up this picture of the heads side and see if you guys can figure out if this is corrosion or what. I wont use brushes or solvents or creams or anything else that would hurt or destroy it more than it already is  compared to the front of the coin, the back is barely touched by scratches, no corrosion just some scratches from frequent wear and tear but is very shiny almost mirror-like Edited by xAGENTxMULDERx
08/23/2012 11:07 pm
|
|
Page 2 of 2
|
Replies: 16 / Views: 3,061 |
Page 2 of 2
|
First Page
Posted 08/22/2012 3:52 pm
