| Author |
 Replies: 16 / Views: 3,023 |
Page 2 of 2
|
|
|
|
Pillar of the Community
United States
1804 Posts |
Pure guess === with out seeing a picture.
It is a broad strike.
|
|
New Member
 United States
31 Posts |
I will post pictures when I get home later this evening I will measure with my calipers
|
|
Valued Member
United States
374 Posts |
I've never heard of it, but weight it if you can... And measure the diameter with calipers.
|
|
Moderator
 United States
23522 Posts |
Interesting. It's a physical impossibility, of course, for the coin to be struck at a larger-than-normal diameter. The same collar which causes the reeding - which you've found to be OK - also precisely sizes the coin and prevents an oversize. So I'm pretty interested in seeing this one and trying to figure out how it came to be.  |
|
New Member
United States
31 Posts |
The coin is a 1984 d   |
|
New Member
United States
31 Posts |
1984 coin on the left missing the ridged or reeded edge so shouldn't it be smaller than normal not bigger  |
|
Valued Member
United States
374 Posts |
It doesn't look like the coin ever had reeds to begin with...
|
|
New Member
United States
31 Posts |
How is that even possible? it has some very faint reeds but they a very faint
Edited by a1big_trucken
07/05/2014 7:19 pm
|
|
Valued Member
United States
374 Posts |
Well, if it has some reeding and doesn't look broadstruck, I just don't know what would make it larger.
|
|
New Member
United States
31 Posts |
|
|
Pillar of the Community
United States
2077 Posts |
I would say it's not a counterfeit because it is clad. I don't believe anyone but the mint has access to clad coin stock, nor could they afford to make it themselves.
Without reeding, it may be broadstruck, just not to the extent typically seen. How does the weight compare?
|
|
Rest in Peace
United States
1943 Posts |
The diameter of a US Quarter is 24.26 mm. But many collectors forget there is a tolerance that goes with this size. I don't know the tolerance off hand but I would think both of the above quarters would be within tolerance. The cause of the smooth edge could be caused by either a broadstrike error or simply wear. If you can see faint reeding lines then I would think this is just a normal worn quarter.
Also if one of the mods would move this to the error section of the forum you might get more responses to it.
|
|
New Member
United States
31 Posts |
|
|
Rest in Peace
United States
1943 Posts |
The weight is again within tolerance of the given weight of 5.67 grams.
|
|
Pillar of the Community
United States
2077 Posts |
Just looked at your calipers and noticed that they are set to metric. I thought it was off by .070 inches which would be a lot. However, .070 mm is almost nothing. Think this is just a normal coin.
|
|
Page 2 of 2
|
Replies: 16 / Views: 3,023 |
Page 2 of 2
|
First Page
Posted 07/05/2014 12:59 pm
