| Author |
 Replies: 32 / Views: 10,840 |
Page 3 of 3
|
|
|
|
New Member
 Canada
7 Posts |
If you weighed every planchet that was turned into a coin during 1979 , 1980 , and 1981 you would not get 3.24, 2.8 and 2.8 every single time. There is going to be some fluctuations and I believe 0.01 is an appropriate fluctuation weather it be 2.9 or 2.7. I am getting this coin certified I will post the results for those who are curious. Thanks for all your input, very much appreciated.
|
|
Pillar of the Community
Canada
823 Posts |
YOU WILL BE WASTING YOUR MONEY !!
You can see the obvious scratch marks, then someone scratched the "rectangle" with something else.
Planchets are blank and smooth before striking (I have some), not all marked up, and they have a rim, which would hit against the other planchet's rim and squish towards the middle, not disappear.
|
|
Bedrock of the Community
Canada
21652 Posts |
I don't know why some people waste our time on here.
No matter how many people more knowledgeable tell them the
right answer, they still insist that they are right.
If the OP wants to waste his money getting it graded, then
I say go ahead it's not my loss.
I'm sure this will be the last we hear of this coin.
Edited by JimmyD
12/15/2018 08:32 am
|
|
Pillar of the Community
United States
4692 Posts |
Like those file marks aren't an obvious clue! The TPGs should put out a "greatest hits" of goofy coin submissions!
|
|
Pillar of the Community
Canada
2301 Posts |
|
|
Moderator
 Canada
10463 Posts |
Quote:
I am getting this coin certified I will post the results for those who are curious. There is only one certifier in Canada who handles errors, and that is CCCS. It will cost you about $20 for a single coin submission (plus shipping). NGC and PCGS in the US do certify errors, and with the CAN-US currency exchange, and shipping costs, it will cost you $75 (approximately) for a single coin submission. Or, you could listen to the experts here, me being one of them (I collect Canadian small cent errors): - your coin was not struck on a split planchet http://goccf.com/t/330437- your coin was not struck through another coin (note the rim on the blank side) http://goccf.com/t/271556You need to learn about the minting process, before you can make such bold assumptions. Even blank planchets, have raised rims. http://goccf.com/t/194021You have a full rim on one side, and no rim on the other, therefore it was NOT struck on a Type 1 blank. You have a normal coin whereby someone filed or ground down the reverse. I could make that same "error" in about 10 minutes in my garage. It is junk, it is worth nothing more than a conversation piece... Transition strikes do occur, but are uncommon: http://goccf.com/t/285686Lastly,  to CCF - there are a ton of threads here on errors, so take advantage of the CCF search engine and open your mind - when it comes to errors, we are all always learning... "Discovery follows discovery, each both raising and answering questions, each ending a long search, and each providing the new instruments for a new search." -- J. Robert OppenheimerContent of this post is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License. See: http://creativecommons.org/licenses...0/deed.en_USMy eBay store
|
|
Moderator
Canada
10463 Posts |
Quote:
I believe 0.01 is an appropriate fluctuation weather it be 2.9 or 2.7. It is not, the range of tolerance is much more than 0.1 grams. Go ahead and open a mint roll of uncirculated coins from any year and weigh them... the results might surprise you... "Discovery follows discovery, each both raising and answering questions, each ending a long search, and each providing the new instruments for a new search." -- J. Robert OppenheimerContent of this post is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License. See: http://creativecommons.org/licenses...0/deed.en_USMy eBay store
|
|
New Member
Canada
1 Posts |
Hi There, I think I found the exact same penny. Did you ever figure out what happened to yours? We were playing poker with some old pennys when I found this one. Cheers, Tim    |
|
Pillar of the Community
Canada
1624 Posts |
Same answer for your coin: it's been ground down. |
|
Moderator
United States
189767 Posts |
One Sided Queen, to the Community! |
|
Bedrock of the Community
Canada
21652 Posts |
to the CCF Agree with johnnysprawl Same type of coin, same answer. It has been ground down. No value over one cent. Edited by JimmyD
12/28/2020 08:38 am
|
|
Valued Member
Canada
98 Posts |
Considering the original poster has not posted the slabbed coin as proof of their convictions, (it has been 2 years since the original post) that the experts here are correct with their assumptions about it being filed or ground down.
|
|
Bedrock of the Community
Australia
21788 Posts |
Grinding scratches left behind.
|
|
Pillar of the Community
Canada
1224 Posts |
I'd like to see better pictures of the reverse to my eyes I do see a rim where the supposed file marks end but how could the one filing leave the rim. Side on pictures with the coin out of the holder would also help. Cheers, Bill  |
|
Pillar of the Community
Canada
2428 Posts |
Easily reproduced with an Electric Bench Grinder.
|
|
Page 3 of 3
|
Replies: 32 / Views: 10,840 |
Page 3 of 3
|
First Page
Previous Page
Posted 12/15/2018 12:19 am
