| Author |
 Replies: 20 / Views: 2,697 |
Page 2 of 2
|
|
|
|
Formerly nancyc
Australia
5385 Posts |
Maybe it's a raccoon.  life is a mystery to be lived not a problem to be solved
|
|
Valued Member
 United States
123 Posts |
My android phone can not take a decent picture. Not sure when I can get a better photo.
|
|
Pillar of the Community
United States
5964 Posts |
Try shooting it through your loupe.
|
|
Valued Member
United States
241 Posts |
Don't know what's climbing up the wall, but if 85% are 2015-Ps, are you looking for the new DDR that was recently discovered? |
|
Pillar of the Community
United States
898 Posts |
Hey I was just in Myrtle last weekend. Hope you enjoyed it as much as I did.
|
|
Valued Member
United States
80 Posts |
shoot it through a loupe? that sounds like a pretty good scope on that gun.
|
|
Pillar of the Community
United States
4932 Posts |
|
|
Valued Member
United States
123 Posts |
would this be considered a mint error or is the chip too small?
|
|
Pillar of the Community
United States
2376 Posts |
Depends on where and what its on. There is a whole segment of collecting built around cracks, chips and breaks in the liberty of Lincoln cents collectively called BIE's
It can be called an error
Edited by stoneman227
07/23/2015 8:45 pm
|
|
Valued Member
Canada
488 Posts |
I think it's that guy who jumped the whitehouse fence, he's at it again!
|
|
Bedrock of the Community
United States
62064 Posts |
Could be just coin contact in that area. Need a closer image to tell for sure.
|
|
Valued Member
United States
123 Posts |
below is a close up.  |
|
Pillar of the Community
United States
2589 Posts |
Thats definitely a die chip, a good sized one as well for a modern coin
|
|
Pillar of the Community
United States
7390 Posts |
Tick tock, tick tock, the mouse ran up the clock  Looks like a suggestive die chip |
|
Bedrock of the Community
United States
62064 Posts |
I agree it is a die chip. There looks like coin contact on the base of the building.
|
|
Page 2 of 2
|
Replies: 20 / Views: 2,697 |
Page 2 of 2
|
First Page
Posted 07/21/2015 8:18 pm
