| Author |
Replies: 11 / Views: 1,740 |
|
|
Moderator
 United States
56855 Posts |
A few questions. How should I label this? Any collector interest? Value if any? Thanks all,John1  
|
|
|
|
Valued Member
United States
261 Posts |
Interesting lamination? I see there are a slew of other vertical lines on the coin in front of and into the bust. Some must collect these but no idea on value. It would go into the oddities stash for me.
|
|
Pillar of the Community
United States
613 Posts |
|
|
Valued Member
United States
452 Posts |
Looks like lamination to me as well. It doesn't spark my collectors interest.
|
|
Pillar of the Community
United States
2376 Posts |
Looks like the plating split along a linear plating bubble. Split plating.
|
|
Pillar of the Community
United States
3331 Posts |
This is a copper plated cent - the plating is 8 microns thick. I am not certain that it is able to sustain a lamination peel. I did not know the zinc alloy contained any kind of lamination.
|
|
Bedrock of the Community
United States
17884 Posts |
Several times I have seen people say that a zinc cent can't have a lamination. Why not? What causes a lamination? A gas bubble or foreing inclusion in the ingot that gets rolled out to create the strip. Frequently it is because of problems in the alloy mix but there is no reason why a bubble can't happen in a pure metal strip, especially one with a low melting or boiling point such as zinc. Get the melt a little too hot and gas bubbles can form in the melt from vaporized zinc.
Yes this could just be a split plating bubble, but it does look like it has a good chance of being an actual lamination.
|
|
Pillar of the Community
United States
2376 Posts |
I'm sure you could truly say a plating bubble is actuallya spot where the plating has delaminated from the core since the plating and the core are different layers of the coin. If the bubble were large enough it would be very much like a "traditional" lam
|
|
Bedrock of the Community
United States
62064 Posts |
What does the reverse look like and the edge in that area. A closer shot might be helpful. You might also check to see if under a raised area if there is copper plating? If so it may have been struck through a piece of copper foil that came off another cent? If so you might see there is folds over the edge at the ends of the raised area.
|
|
Pillar of the Community
United States
3331 Posts |
I think it is really very interesting! I would like to own it! I don't know that I would want to pay very much, though!
|
|
Moderator
  United States
56855 Posts |
If you click on the image it does get bigger. I will look the coin over more tomorrow. John1 
|
|
Moderator
  United States
56855 Posts |
Edited by John1 09/22/2015 07:16 am
|
| |
Replies: 11 / Views: 1,740 |
|