| Author |
 Replies: 33 / Views: 4,104 |
|
|
|
Bedrock of the Community
United States
62064 Posts |
The reverse side was so minor, but my eye caught it after I has spotted it on the obverse.
|
|
Bedrock of the Community
United States
62064 Posts |
Here is a updated images of the clipped areas:  Edited by coop
10/29/2016 3:52 pm
|
|
Pillar of the Community
United States
3331 Posts |
Those images are quite helpful, too!
Thanks!
|
|
Rest in Peace
United States
7075 Posts |
This one is tough for me. The shape of the clip just looks so wrong to me that I am certain that I would have dismissed it as damaged.
|
|
Moderator
 United States
56855 Posts |
 John1  |
|
Bedrock of the Community
United States
62064 Posts |
Quote:
ErrorCoins222: Genuine curved clip - the die flow along the clip being the best evidence. The shape of the clip is strange, however the shape can be distorted under heavy pressure between two dies. I believe that is why the shape is distorted. During the strike the planchet altered it shape because of the area clipped out was large. |
|
Pillar of the Community
United States
3181 Posts |
This is a tough one! I would think with such a large clip, the die flow would be more evident  |
|
Pillar of the Community
Canada
870 Posts |
I have some wider large clips and yes, the clip is distorted (not perfectly curved) but I have never seen one so angular. I too would have dismissed this one.
|
|
Valued Member
 United States
127 Posts |
Has anyone ever seen an inside or outside corner clip before?...they obviously exist..otherwise they wouldn't be listed anywhere..I just can't find a pic anywhere of one..lol
|
|
Bedrock of the Community
United States
62064 Posts |
Are you talking about an edge clip?
|
|
Valued Member
United States
127 Posts |
|
|
Bedrock of the Community
United States
62064 Posts |
That was what I thought you were thinking of. Over the edge on two corners. The that would be missing two sides forming a corner, not an corner inside towards the center.  |
|
Valued Member
United States
127 Posts |
|
|
Bedrock of the Community
United States
62064 Posts |
I can't think of an way there could be an inside corner on the blank. Outside corner, but not an inside corner. The punching is round. Falling over to edge would create the example I created above. But inside corner that is at a right angle, I can't see happening.
|
|
Pillar of the Community
United States
3331 Posts |
|
| |
Replies: 33 / Views: 4,104 |
First Page
Posted 10/29/2016 1:09 pm
