I was looking first at the mintmark and wondered if it were a RPM. But after not finding one like that on that area, I looked at reflection on your images. Note if there is glare, it is always in the same location? You can see it on the date/mintmark/rim. So you might try a diffuser/increasing diffuser to reduce the reflection. Depending on your light source, this can be done for little expense. If you could post an image of your lighting setup. I think we can fix this issue. The glare can hide things you see on your scope, but the images show the glare. That usually means either too much light, too low of an angle for light, or not using a diffuser strong enough to remove the glare issue. Looking forward to see you light source images.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use