I prefer the correct terms: Spread: The movement/miss alignment of the die creation with the hub process. I refer the Single squeeze doubled dies as die distortion during the creation of the die. This distortion is seen a altered devices, like an over inflated Bicycle tube: When you see them side by side, they look more obvious.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use