| Author |
 Replies: 18 / Views: 4,775 |
Page 2 of 2
|
|
|
|
Pillar of the Community
 United States
1572 Posts |
Hey Coop, I hate to show my ignorance here but, since I am less than sure what a partial collar looks like, could you hook me up with photos of partial collar coins so I can better answer your question? Thanks, I appreciate it.
|
|
Pillar of the Community
United States
1572 Posts |
Collector-Corner: I have seen examples (very few) of the type of the strike through metal 1988-p cents you are referring to and this is different. I truly can see no trace of the inits in-hand or under the scope. Thank you for your help with this, I appreciate it.
|
|
Bedrock of the Community
United States
62064 Posts |
 On the impartial collars the planchet was not fully in the collar that makes the coin round or reeded. On some MAD coins there maybe a weakness where the die is over the edge of the rim of the coin:  The area where the die is not present does not fully form the devices. Note the second image. The weakness on AMERICA. Sometimes a partial collar's die isn't over the part of the design. So I wondered if it affected the "FG". It is probably die abrasion or struck through error. Not a keeper in my book. Others get excited about them They used to send them into be graded and this eventually stopped as it was not actually missing the device on the die. They are something people collect today and later on spend. |
|
Pillar of the Community
872 Posts |
take a look at the area below the "CENTS".... is that an area that looks like it has been struck through metal ? Typically struck through metal leaves this almost Cud impression on the rim. If it looks like struck through metal, maybe the die didn't strike the die with significant strength, resulting in no designer initials. Maybe its the way my monitor shows the designer initials area (23 inch monitors), or maybe its just me eyes are trying to put an FG there. I've gone through about 30,000 pennies in about 4 months, so I think the FG is engraved in me brain ! = Þ If its gone under a scope, then, I'll take your word for it. |
|
Pillar of the Community
United States
1572 Posts |
Coop: The rim looks fairly normal to me-  CollectorCorner: I think what you are referring to is just glue or some similar substance, whatever it is it is raised from the surface.  Thanks to both of you for helping me on this.
|
|
Valued Member
United States
388 Posts |
I have found a couple examples of missing FG, and even a couple that have no lincoln in the memorial. Glad you posted this. Good info.
|
|
Bedrock of the Community
United States
62064 Posts |
So it may be die abrasion or a filled grease die problem.
|
|
Moderator
 United States
56855 Posts |
I think it's die abrasion. John1  |
|
Pillar of the Community
United States
1572 Posts |
Thanks to all. It's one of those coins that causes you to do a double-take when you are first examining it.
|
|
Pillar of the Community
743 Posts |
I agree it is die abrasion. You can see the fine raised lines all over the obv. & rev. Nice one to hold onto. You never know what will be collected in 30 years. This is something in the die not like a struck through that only happens occasionally on a die and is wiped away. This is from a mint worker or something scrubbing a way a severe clashed die.
|
|
Pillar of the Community
743 Posts |
A 1988-D recently sold for about $12 that had no fg but I think it looks like more of a small broadstruck look to it because the edge around the rim looks stretched. It also has a lot of plating bubbles. I am surprised it sold so for so much. http://www.ebay.com/itm/1988-D-Linc...047675.l2557 |
|
Moderator
United States
56855 Posts |
Well who ever bought that coin did not use the zoom feature because I can the F and the G,faint but they are there.So not really missing the FG  John1 |
|
Pillar of the Community
United States
1944 Posts |
i found a 88P (missing FG) also...  |
|
Pillar of the Community
United States
601 Posts |
This variety is fairly well known (to some)- it's featured in the cover page of a recent edition of Strike It Rich. No value stated in the book, but I sold the BU plate coin for $100 and have gotten $20 for circulated examples from interested collectors.
The variety is definitely a result of die abrasion. It comes in 2 different states, without FG and without FG and Lincoln inside the memorial. I have not studied examples side by side to discern whether they are from the same die. There are numerous threads here and on LCR about the coin.
|
|
Bedrock of the Community
United States
62064 Posts |
Here is an almost missing Abe on this one. The designer initials are missing. (Just noticed that.)  |
|
Page 2 of 2
|
Replies: 18 / Views: 4,775 |
Page 2 of 2
|
First Page
Posted 11/17/2013 12:30 am
