| Author |
 Replies: 16 / Views: 1,520 |
Page 2 of 2
|
|
|
|
Rest in Peace
United States
17900 Posts |
|
|
Pillar of the Community
7234 Posts |
|
|
New Member
 United States
26 Posts |
Here is one a little closer. Bout as good as I can get it.  |
|
New Member
United States
26 Posts |
Just making sure I'm clear on where I am looking  |
|
Pillar of the Community
United States
1335 Posts |
|
|
Pillar of the Community
United States
3463 Posts |
I think you're too close. Try zooming out a little and move the light source.
I know what you are looking for, but I'm not seeing it in these images.
It is a very light RPM which would be difficult to see, and may have faded even more in later die states.
|
|
Moderator
 United States
56855 Posts |
The op thinks it is a misplaced mint mark not an RPM. I checked Wexler site and it only goes to 1982 for RPM's.I do not think it is an RPM or a misplaced mint mark. John1  |
|
New Member
United States
26 Posts |
|
|
Moderator
United States
56855 Posts |
Thank you SeekerxofxTruth for the link. I went to his site and clicked on RPM list and it did not have any past 1982. John1 |
|
Bedrock of the Community
United States
62064 Posts |
Looks like a die flow field. If this was a RPM, then it would be raised above the field. If the die flow was not there, this thread would not of happened. Just VLDS die.
|
|
Rest in Peace
10197 Posts |
I see all kinds of things...you will at that high of mag, see every single small flaw in die or planchet surfaces, do that to any metal surface, even the "smoothest" like a sharpen blade, and you will see just how rough that edge is.  |
|
New Member
United States
26 Posts |
Yeah that's what I am worried I'm doing here. Those lines that turn 90 degrees lining up with the curved scratch are tricky. But I can make a lot of shapes to.
The issue I have with the zoom is I'm only using my phone camera with a clip on macro lens. So I can take blurry pics zoomed out. Or hyper focused pics close up.
|
|
Pillar of the Community
United States
4404 Posts |
|
|
New Member
United States
26 Posts |
I think these pics might show it better   |
|
Pillar of the Community
United States
3463 Posts |
|
|
Page 2 of 2
|
Replies: 16 / Views: 1,520 |
Page 2 of 2
|
First Page
Posted 01/10/2018 8:12 pm
