| Author |
 Replies: 16 / Views: 2,533 |
Page 2 of 2
|
|
|
|
Pillar of the Community
United States
4211 Posts |
 Z143!  I think cotton gloves are the best for handling coins. IMHO |
|
Bedrock of the Community
Canada
24885 Posts |
To the Forum. |
|
Bedrock of the Community
13014 Posts |
Gloves are unnecessary especially on circulated coins, just wash your hands first and hold them by the edge.
That said if you insist on using them medical ones are likely the best with cotton being the worst. Dirt and lint stick on cotton to much and they sacrifice the most dexterity.
|
|
Bedrock of the Community
United States
94367 Posts |
The TPGs don't use any kind of glove, even on the most valuable coins, so I don't either.
|
|
Moderator
 United States
189117 Posts |
to the Community! Quote:
Gloves are unnecessary especially on circulated coins, just wash your hands first and hold them by the edge. |
|
Pillar of the Community
Canada
5397 Posts |
Gloves .... a total waste of time and completely unnecessary!
Better advice , don't talk over or breathe on a coin . Only handle by the edge
with clean hands over a soft surface ,just in case of an accidental drop.
|
|
Moderator
United States
189117 Posts |
Sound advice.  |
|
Pillar of the Community
Canada
5246 Posts |
Quote:
Sound advice You don't want the sound of a proof coin hitting a hard surface! |
|
Pillar of the Community
 United States
7955 Posts |
Natural rubber has usually been crosslinked (vulcanized) with sulfur, which is especially bad for copper and silver. I have a few 20th century bronze coins that obviously had a rubber band around them at one time, and now have a dark discolored stripe across the surface. Even if the exposure from a glove is brief, I would not do it.
Synthetic rubber is chemically different, and generally more inert, though these often have some kind of slip agent on them (very fine cornstarch, for instance) so that they don't stick together. This can come off on the coins.
My understanding is that cotton is recommended for handling coins because it has none of those issues. If lint is an issue, you can use compressed air to deal with it.
Personally I am just not that fastidious with my coins (I also do not have modern high grade MS or proofs in my collection). I am in the same camp as Pacificoin and basebal21.
|
|
Bedrock of the Community
United States
20753 Posts |
I've never used any kind of gloves on coins in well over 60 years now. No problems with my coins. |
|
Rest in Peace
United States
18456 Posts |
I find using any type of glove cumbersome . I just wash my hands and hold the coin by the edges . Place a dish towel on work table or paper plate. I'm sure we all have our own little methods . Just a little tip , don't blow on any coin or holder to remove dust, hair or cardboard shaving's .  |
|
Pillar of the Community
United States
6514 Posts |
Sound advice T-Bop. If you were to blow on a coin in 6 months you'd discover your coin spotted. My older son had a protective slide out of his Whitman LMC album. That exposed 12 red coins. He blew on his album to remove a small piece of paper. Fast forward 6-9 months and half of the coins had itty bitty black spots starting to bloom. Check out my counterstamped Lincoln Cent collection: http://goccf.com/t/303507Edited by chafemasterj
03/31/2019 12:23 pm
|
|
Pillar of the Community
United States
1005 Posts |
Agree the best way is to just wash hands thoroughly then handle with bare fingers. But if I were to take proofs out of packaging or flips, I would probably put on a pair of tight nitrile gloves to avoid any printing risk on the edges. Fingers are constantly secreting corrosive oils from sweat ducts.
|
|
Moderator
United States
189117 Posts |
Quote:
You don't want the sound of a proof coin hitting a hard surface! |
|
Bedrock of the Community
United States
17884 Posts |
Quote:
Better advice , don't talk over or breathe on a coin . Yes, forget the gloves, but a surgical mask might be a good idea. |
|
Page 2 of 2
|
Replies: 16 / Views: 2,533 |
Page 2 of 2
|
First Page
Posted 03/30/2019 4:53 pm
