| Author |
 Replies: 16 / Views: 4,441 |
Page 2 of 2
|
|
|
|
Bedrock of the Community
United States
10635 Posts |
Post mint damage ( PMD). How? Why? Maybe heat or chemical exposure. There are a million ways PMD happens. This coin did not leave the mint looking this way. The rims are a dead giveaway. Not every coin is an error coin, sorry. Keep searching!  |
|
New Member
 United States
23 Posts |
With the new 2021 quarters that just came out and my boyfriend getting surgery in California I asked for him to bring back a few rolls of quarters from the bank there to bring back here to PA for me and this was in the roll. I have never seen this type of error before on both sides this bad if someone went through all the bull to try and pull that off then I really dont think they would just put it back in circulation like that. and give me a second on the weight, i'll do that now
|
|
New Member
United States
23 Posts |
My scale is .0 only I'm sorry to say, it used to be my packaging one but it came out to 5.7g
|
|
New Member
United States
23 Posts |
|
|
New Member
United States
23 Posts |
|
|
Bedrock of the Community
United States
12477 Posts |
Various types of welders and torches can definitely reach temperatures that will melt/deform copper-nickel.
In Memory of Crazyb0 12-26-1951 to 7-27-2020
In Memory of Tootallious 3-31-1964 to 4-15-2020
In Memory of T-BOP 10-12-1949 to 1-19-2024
Edited by spru
05/20/2021 04:25 am
|
|
Moderator
 United States
56855 Posts |
My vote goes to heat damage, PMD. John1  |
|
Bedrock of the Community
United States
62064 Posts |
On coins from a house fire they develope a bubble in them:  |
|
Bedrock of the Community
United States
94367 Posts |
Just doesn't look quite like any other heat-damaged coin I've seen.  to the CCF! |
|
Bedrock of the Community
Canada
21663 Posts |
There are two things that can happen to a coin, an error while being struck or one of countless ways a coin
can be damaged afterwords. As that is not an error, that leaves damage, even if you don't know how it happened.
|
|
Pillar of the Community
United States
4846 Posts |
Absolutely not an error. My bet is that it had some interaction with a soldering iron and some solder.
In any case, it definitely is not a mint error.
|
|
Bedrock of the Community
United States
62064 Posts |
What the weight? Looks like someone solder it down a bunch. If so it should be over weight.
|
|
New Member
United States
1 Posts |
Hi, I may be wrong, but looking at the 4th pic down (obverse), diagonally across the coin - it almost looks like the imprint of a dime (reverse of dime)?
|
|
Moderator
United States
190135 Posts |
to the Community, Natia088! |
|
Moderator
United States
98564 Posts |
to CCF Natia088! I went back and I don't see it.  |
|
Page 2 of 2
|
Replies: 16 / Views: 4,441 |
Page 2 of 2
|
First Page
Posted 05/20/2021 12:24 am
