| Author |
 Replies: 17 / Views: 2,814 |
Page 2 of 2
|
|
|
|
Pillar of the Community
Canada
1530 Posts |
What is the weight of the coin?
|
|
Pillar of the Community
Canada
627 Posts |
I'm skeptical of EVERYTHING. My first thought is that some one had it chromed dipped. Did you know that you can dip anything into liquid chrome and have it "chromed". Lets see what others have to say
|
|
New Member
 United States
6 Posts |
|
|
Pillar of the Community
Canada
857 Posts |
Looks plated with something to me, as far as I know only one king George V small struck on a dime planchet is known.
|
|
Pillar of the Community
Canada
5324 Posts |
Time for an XRF, it's way underweight if your scale is correct
|
|
Pillar of the Community
Canada
1622 Posts |
My first thought is plated, as it looks to be the same diameter as a normal 1929 cent and is stuck just as well too.
Can you post a photo of the edge and of the other side?
|
|
Valued Member
Canada
153 Posts |
Color and weight suggests aluminum - seems unlikely. Better photos needed.
Edited by JGpenny
05/12/2020 7:40 pm
|
|
Moderator
 Canada
10463 Posts |
Full collar, full strike... so I am suspect... something just looks off. Can you post a photo of both sides, straight on at the coin?
"Discovery follows discovery, each both raising and answering questions, each ending a long search, and each providing the new instruments for a new search." -- J. Robert OppenheimerContent of this post is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License. See: http://creativecommons.org/licenses...0/deed.en_USMy eBay store
|
|
Pillar of the Community
Canada
1186 Posts |
Possibly fake?, I say it with respect to the OP, but look at the date compared to the copper, the eyes of the 9's look far too big, the numbers in general look bigger than the ones on the copper, if you look at "CENT" the "T" on the coin in question is longer, the N's don't match and the entire details of the reverse look far too large. Not to mention it looks as if it was just made.
Better pictures may clear up most of what I pointed out, but I'm no expert, I just like to pick at details and point things out.
Finding and discovering modern Canadian doubled die varieties since 2018. 2023 Recent Publications: Modern Canadian Doubled Die Varieties - First Edition PDF & Paperback https://www.mcddv.ca (website currently down for maintenance as of 08/01/2024) |
|
New Member
United States
6 Posts |
|
|
Moderator
Canada
10463 Posts |
Bit of discolouration on the rim, I suspect it is zinc plated, but also might have been coated with either a silver or mercury wash.
Either way, given the nature of the strike, it looks like a normal coin that has been coated.
"Discovery follows discovery, each both raising and answering questions, each ending a long search, and each providing the new instruments for a new search." -- J. Robert OppenheimerContent of this post is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License. See: http://creativecommons.org/licenses...0/deed.en_USMy eBay store
|
|
Pillar of the Community
Canada
1622 Posts |
The RCM didn't strike any foreign coins in 1929.. |
|
Pillar of the Community
 Canada
5593 Posts |
Again, find the weight .. the 2 g that you stated before is over 30% light. If nothing else, get a balance scale and measure it against a copper '29.
|
|
Pillar of the Community
Canada
5324 Posts |
Just stack the two coins and take a side view pic, the silver one should be much thinner if your scale is correct
|
|
Pillar of the Community
Canada
870 Posts |
you could also test it by carefully scratching the rim to see if it is copper underneath. that should be a last resort though because if it is legit, that would damage the coin.
|
|
Page 2 of 2
|
Replies: 17 / Views: 2,814 |
Page 2 of 2
|
First Page
Posted 05/12/2020 4:48 pm
