| Author |
 Replies: 17 / Views: 1,890 |
Page 2 of 2
|
|
|
|
Moderator
 United States
56855 Posts |
|
|
Bedrock of the Community
United States
94367 Posts |
|
|
Pillar of the Community
United States
1427 Posts |
|
|
Pillar of the Community
 United States
6514 Posts |
In most all cases an acetone bath can't hurt so why not.  Check out my counterstamped Lincoln Cent collection: http://goccf.com/t/303507 |
|
Valued Member
 United States
485 Posts |
 Ok good advise, thank you! How long does one normally soak the coins? |
|
Pillar of the Community
1110 Posts |
I would say quite a few minutes or longer. Whatever it is, it looks like it's baked on pretty good. I would submerge a couple of Q-tips into that acetone with the coin. Hold the coin steady with one and gently (VERY GENTLY) wipe the coin with the other one. See if anything happens. Don't force it or press hard on the coin while you GENTLY rub or wipe it.
Let's see the after pictures.
|
|
Bedrock of the Community
United States
19261 Posts |
While doing all that, avoid inhaling the fumes...
|
|
Moderator
United States
56855 Posts |
Also keep in mind that acetone dies not remove all adhesives, like epoxy for example. John1  |
|
Pillar of the Community
1110 Posts |
Quote:
Also keep in mind that acetone dies not remove all adhesives, like epoxy for example. Well, at least we know where your mind is!...............................on the coins minting process.   Edited by MOS0239
12/27/2020 3:46 pm
|
|
Valued Member
United States
485 Posts |
 You guys were right! After soaking for an hour the cloth effect is totally gone! Thank you for the expert advice! |
|
Pillar of the Community
Canada
3733 Posts |
|
|
Pillar of the Community
1110 Posts |
Let's see the entire coin, both sides.
|
|
Valued Member
United States
485 Posts |
|
|
Bedrock of the Community
United States
94367 Posts |
Ta-da!   |
|
Pillar of the Community
1110 Posts |
And there we go, another successful thread!  ! |
|
Page 2 of 2
|
Replies: 17 / Views: 1,890 |
Page 2 of 2
|
First Page
Posted 12/27/2020 11:39 am
