Welcome to Coin Community, TreyB. Your Half looks to be formerly mounted in a piece of jewelery; the irregularities are the physical points of mounting.
I actually picked up the quarter to use as in inlay in a coin cabinet of my own design which I will build when I get everything rounded up that I need to do the job.
There's a good chance that you can remove the solder completely. What you need is a safe way to hold the coin while it's heated with a soldering pencil, and high pressure compressed air to blow the liquified solder off of it once it's melted.
I'll lt you know how mine works out. I know without a doubt that the quarter's original surface is long gone, so I'm not worried about heating it.
More than likely your soldering pencil isn't going to do a thing to it. When they are making jewelry they don't use the lead or tin based solders that are used for electronics (melts around 400 degrees) They use a silver solder and the melting temperatures are typically in the 1100 to 1400 degree range.
Well, I think that would depend upon whether or not it was done by a jeweler, or some guy down the street.
I just successfully removed the mounts from mine, and it doesn't match the 1876-S half. The quarter was minted at Carson City. Still trying to get the rest of the crap off of it right now.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use