Looks more like contact flattening on part of the "8". They should be a lot wider on the devices if it were a doubled die. The outside edges of the 8 should be wider then the inside part of the 8s. Here is another example:
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use