Coin Community Family of Web Sites Join Thousands of Coin, Bullion, & Money Collectors
Vancouvers #1 Coin and Paper Money Dealer 300,000 items to help build your collection! Royal Estate Auctions - $1 Coin AuctionsRoyal Canadian Mint products, Canadian, Polish, American, and world coins and banknotes. Specializing in Modern Numismatics Coin, Banknote and Medal Collectors's Online Mall Join Thousands of Coin, Bullion, & Money Collectors








Username:
Password:
Save Password
Forgot your Password?


This page may contain links that result in small commissions to keep this free site up and running.

Welcome Guest! Registering and/or logging in will remove the anchor (bottom) ads. It's Free!

1985-D Roosevelt Dime Unusual

To participate in the forum you must log in or register.
Author Previous TopicReplies: 2 / Views: 1,108Next Topic  
Pillar of the Community
CoinMasters's Avatar
United States
5964 Posts
 Posted 03/19/2016  6:44 pm Show Profile   Bookmark this topic Add CoinMasters to your friends list Get a Link to this Message Number of Subscribers
I posted one similar to this one a while back. I remember Mike told us it was a product of Inadequate Upset and Excessive Obverse Die Convexity. Now I'm a simple man, so I realized it must have had too much curvature on the obverse die and not enough upset. I didn't know what upset was, but as I can only absorb so much at a time, I was satisfied. After finding this dime, I wish I'd have asked about it.
In other words, I don't have a clue what this one is. Any help would be appreciated.

1985-D--Roosevelt-Dime-Unusual

1985-D--Roosevelt-Dime-Unusual

1985-D--Roosevelt-Dime-Unusual
Pillar of the Community
ErrorCoins222's Avatar
United States
1699 Posts
 Posted 03/19/2016  8:29 pm  Show Profile   Bookmark this reply Add ErrorCoins222 to your friends list Get a Link to this Reply
After a blank is punched out of the sheet, it is sent through an upsetting machine. Essentially what the upsetting machine does is force the blank into a smaller and smaller diameter, which builds up the thickness of the perimeter of the planchet, giving it a thicker rim - called a "proto-rim". This rim helps in many ways, one of which is allowing for a better strike of the peripheral design.

If the upsetting machine isn't set correctly, the proto-rim may not be large enough for the coin to get a strong peripheral design during striking - this would be inadequate upset.
Edited by ErrorCoins222
03/19/2016 8:30 pm
Pillar of the Community
CoinMasters's Avatar
United States
5964 Posts
 Posted 03/19/2016  8:55 pm  Show Profile   Bookmark this reply Add CoinMasters to your friends list Get a Link to this Reply
I see. Thank you for telling me that. Now that I know that, this one might be a candidate for Inadequate Upset. There are a lot of perimeter devices that appear to me to be weakly struck. Just guessing
  Previous TopicReplies: 2 / Views: 1,108Next Topic  

To participate in the forum you must log in or register.



    




Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited.
Contact Us  |  Advertise Here  |  Privacy Policy / Terms of Use

Coin Community Forum © 2005 - 2026 Coin Community Forums
It took 0.24 seconds to rattle this change. Forums