I found this this morning in some pocket change. it looks to me like PMD. Any thoughts on how it was done? I was thinking perhaps a dremel or some other type of rotary tool
If t had been a fraction left, it would have been a circle impression. That kind of PMD is anyone's WAG. metal shaving on a garage shop floor and run over by a loaded pallet mover?...Could even have been a nail counter sink that Little Johnnie's cousin Jo-jo in the Prison license plate shop used, or it could have been Uncle Jack's defective capped toothmarks, or...
Come on. That is obviously Johnny's third cousins once removed Bingo Bennie. He specializes in counter sunk partial digest stamps perfect for this work.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use