Under the butt of the rifle, that might just be part of the design Die polishing could remove these from the dies as it ages. The area for the
DDR's are in the centers of the design. Not on the outer edges away from the centers. Always check the listings for the doubled dies for more information on what to look for on the design. Some designs will not have a
DDR it nothing is in that area, like just an open field area. Nothing will get doubled from the hub. So when looking at the Wexler files, if there is not listing, then it maybe on of the issues. Other times it is from none being found yet. So always look at your maps/information from the sites to find out what is and if it is a new listing. But remember locations. Towards the centers of the designs. I call them target areas.

Note the obverse. These will probably not have
DDO on the dimes.

Nose and the door on the reverse area.

Earlobe and motto for the Obverse and the Reverse the center areas of the design. Check the sites for what/where these Doubled Dies can be found. When traveling, you check a map to see your destination. Same on doubled dies. Know where/what to look for
before searching. Otherwise, you could put your car on blocks and go through the motion of getting to your destination
or just be spinning your wheels. Not reaching your destination.
Edited by coop
05/08/2022 12:29 pm