| Author |
Replies: 15 / Views: 1,632 |
|
|
New Member
Canada
4 Posts |
Hi, I was just wondering if this is an error. 
|
|
|
|
Moderator
 United States
188130 Posts |
 to the Community!
|
|
Bedrock of the Community
 United States
25102 Posts |
Welcome to the Forum, Captain! It's a bit hard to tell from the photo, but it could possibly be either a strike-through or a delamination. Can you post a close up of that area?
Inordinately fascinated by bits of metal with strange markings and figures
|
|
Bedrock of the Community
United States
94367 Posts |
Yes, closeup shot would help.  to the CCF!
|
|
New Member
 Canada
4 Posts |
|
|
New Member
 Canada
4 Posts |
 this is the other side of that coin
|
|
Pillar of the Community
United States
505 Posts |
It looks like a lamination peel error. Cool find.
|
|
New Member
 Canada
4 Posts |
thank you all for taking the time to review and reply : )
|
|
Pillar of the Community
United States
630 Posts |
It looks like it happened pre-strike, which is much better than after
|
|
Pillar of the Community
United States
3848 Posts |
Quote: It looks like it happened pre-strike, which is much better than after I disagree, this appears to be a post strike delamination. @Oldgrouchyguy, what speaks that this is pre strike? The design elements would still be visible if it was delaminated post strike due to metal density at different points, so I am curious what your thoughts are.
Suffering from bust half fever. Want to learn how to attribute early half dollars by die variety? Click Here: http://goccf.com/t/434955Shoot me a PM if you are looking to sell bust halves.
Edited by jacrispies 04/06/2023 1:23 pm
|
|
Moderator
 United States
95517 Posts |
 nice lamination.
|
|
Bedrock of the Community
 United States
25102 Posts |
The sharply defined edges of the delamination indicate that it happened post-strike.
Inordinately fascinated by bits of metal with strange markings and figures
Edited by HondoB 04/06/2023 8:03 pm
|
|
Pillar of the Community
United States
630 Posts |
Here are just two examples of a strike over a delamination. You can see that Liberty's nose of the OP's coin has the same detail as the original plane device details. Not a Guarantee, but a really good step towards it...  
Edited by Oldgrouchyguy 04/07/2023 01:49 am
|
|
Pillar of the Community
United States
630 Posts |
Post-Strike Lamination: 
|
|
Pillar of the Community
United States
630 Posts |
If the OP can say that the nose in the field is level with the high point part struck in the lamination, then that would confirm pre- rather than post-strike lamination. The high point in the lamination may even be higher. Since the lamination is pretty deep in that area, the nose part should be appreciably lower
Edited by Oldgrouchyguy 04/08/2023 12:44 am
|
|
Pillar of the Community
United States
630 Posts |
Here is a coin more attune size-wise with the OP's, and is a very good example of Post-Strike Lamination 
|
| |
Replies: 15 / Views: 1,632 |
|