I hadn't noticed the fact that the letters on rounded edge of Obverse were still raised as marve65 pointed out that is interesting not sure how it was done
As stated above, if it was removed why is there still remnants of the devices. They would have been removed. They look like they're falling off the edge. I'm thinking the planchet was punched out of the end or side of the copper sheet where it wasn't straight but curved. Like a ragged or straight clip.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use