My "reduced diameter" 1835 just falls into that hole. You can take a piece of 220 grit sandpaper and roll it into a tight tube to where it will just pass through the hole. You can turn the sandpaper against the direction it's rolled and open the hole a bit. Naturally you'll have to remove all of the coins and acetate slides from that page in order to do it.
I can't really make my hole smaller as easily ... but I may glue a lining into that hole to better accomodate my specimen.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use