| Author |
 Replies: 16 / Views: 1,945 |
Page 2 of 2
|
|
|
|
Pillar of the Community
 United States
3077 Posts |
give me some time got to figure out how to light the edge better
|
|
Rest in Peace
United States
7075 Posts |
|
|
Pillar of the Community
United States
3077 Posts |
better have enuff to share buddy because my dang battery died
|
|
Pillar of the Community
United States
3077 Posts |
think this shows it I have a Polk on the left and the Taylor on the right and I have lined up the UNUM  |
|
Pillar of the Community
United States
6478 Posts |
|
|
Pillar of the Community
United States
3077 Posts |
how rare are these
been looking for another on line aint seen one yet could this be a discovery coin?
Edited by yotie
06/13/2015 08:01 am
|
|
Valued Member
United States
331 Posts |
hold your horses chances are that it is just a very rare variety chances of a discovery coin are very small
Dont want to burst your bubble but hold on
|
|
Pillar of the Community
United States
1249 Posts |
It's weird because the unum looks normal I would like to see all of the edge. Because usually it's either doubled all the way around or you have misaligned edge lettering. But to have double and the last section looks like three stars ? It's odd can we get pictures all the way around it ple ASE |
|
Pillar of the Community
United States
3077 Posts |
well apon futher inspection it has the right amount of stars just not evenly spaced so its not doubling
|
|
Pillar of the Community
United States
6478 Posts |
Ok, now things are getting weird. Maybe it shifted during the hubbing process.
|
|
Pillar of the Community
United States
3644 Posts |
Looks like slipped edge lettering/improperly spaced...how's the rest of the edge?
|
|
Pillar of the Community
United States
6478 Posts |
I think this would be called a, if I am correct on the shifted during hubbing process, a shifted hubbing error. I really don't know, MikeDiomand! Coop! Ken! Where are you! My expertise is not enough!
|
|
Bedrock of the Community
United States
17884 Posts |
If you check the edge 180 degrees away from the area where the stars are too close, you will most likely find a wider gap between letters or words. This is caused by slippage of the coin as the edge die is being pressed into it. It has nothing to do with hubbing of the edge die.
|
|
Pillar of the Community
United States
6478 Posts |
I always thought it was a color, not an edge die.
|
|
Pillar of the Community
United States
1249 Posts |
It is a collar on the proofs but nor on buisness strike coins. So it is just misaligned edge lettering and it holds a premium you should be able to look it up in pcgs. And check ebay and see what they go for . It's not much but it's something |
|
Page 2 of 2
|
Replies: 16 / Views: 1,945 |
Page 2 of 2
|
First Page
Posted 06/12/2015 7:30 pm
