But there's a point missing. Why does it look like this. The reverse area behind the torch is the atprea affected by Feeder Finger Damage. That event caused the beginning of the end for this die. The break down on the die is from the over polishing. So rather than toss the dies, they altered the dies to strike a few more coins. Because no one will notice. But we do.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use