Note the spread is no strong looking on the devices, but when you see them side by side, then you know this is a doubled die. Also note, no need to look at the outside and inside edges of the devices. Spread in the center of the devices. Let me repeat that: Spread in the center of the devices. So if you are searching for the outside/inside edges for a doubled die, remember, that is where you will find Machine Doubling or die wear. (stop looking there)
Here is a side by side with a normal coin:




Here is a side by side of the device with a different look on the same/normal/polished/machine doubling.

Here is a side by side with a normal coin:




Here is a side by side of the device with a different look on the same/normal/polished/machine doubling.

Edited by coop
03/03/2022 5:12 pm
03/03/2022 5:12 pm



































