Good evening everyone, today I have a question about three black dots that appear on the department of treasury seal. I am wondering if this is a printing issue or something done during circulation. Thanks for your help
It's hard to say. It most likely happened during the printing process. It's extremely minor. I couldn't see it on the photo that wasn't enlarged. I'm guessing if you look at notes through a loop, you're going to find minor imperfections.
I must have excellent vision then. The only reason I used the magnifying loop is because I saw the markings with the bill in hand and I wanted a closer look to see if it was ball point pen or something.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use