| Author |
 Replies: 14 / Views: 1,625 |
|
|
Valued Member
Canada
68 Posts |
Are these worthy on getting graded by ICCS? Any opinions would be appreciated. Thanks     |
|
|
|
Pillar of the Community
Canada
867 Posts |
|
|
Valued Member
Canada
444 Posts |
Tough to grade through the plastic. The coins look mint state, but I would only TPG the upper mint state examples of these years. |
|
Bedrock of the Community
Canada
10743 Posts |
|
|
Pillar of the Community
 Canada
9868 Posts |
AU58
MS62
"Dipping" is not considered cleaning...
-from PCGS website
|
|
Pillar of the Community
Canada
1051 Posts |
First one is not MS, it's AU at best IMO.
Second one would be 60 or 62 depending on the nature of the dark area.
|
|
Valued Member
 Canada
68 Posts |
Thanks Everyone for taking the time to give me your opinion. It has been a great learning experience for me posting some coins for your opinion on grades.  |
|
Pillar of the Community
Canada
4911 Posts |
Your 1935 appears to be a swl, if so it is a fairly scarce coin.
Feel free to call me Will.
|
|
Pillar of the Community
Canada
4911 Posts |
It is hard to tell though, could we please have close ups?
Feel free to call me Will.
|
|
Bedrock of the Community
Canada
21648 Posts |
The 1938 is in MS condition and definitely worth getting graded.
(Not sure, but is that a die chip on the island behind the native?)
The 1935 I would say is not worth getting graded.
Edited by JimmyD
08/11/2015 4:54 pm
|
|
Valued Member
Canada
68 Posts |
@dollarman I posted a close up pic of the 1935 and to me it looks like a fwl. @jimmyd I posted a close up pic of the 1938 and I can't see a die chip? not sure where I'm looking though.  And I will be getting this one graded and not the 1935. Thanks   |
|
Bedrock of the Community
Canada
21648 Posts |
This is the "die chip" I was referring to.  |
|
Valued Member
Canada
68 Posts |
@jimmyd I will have to go to my bank next week and double check on that in my hand. Good eye!  Is this rare? |
|
Bedrock of the Community
Canada
21648 Posts |
I guess any rarity would depend on what it is.
I haven't seen this before so I can't really say.
|
|
Pillar of the Community
Canada
4911 Posts |
It appears to be a small toning spot caused by a pin hole sized hole in the plastic, note the dark spot and then hole like looking thing above it?
Feel free to call me Will.
|
| |
Replies: 14 / Views: 1,625 |
|
Posted 08/03/2015 6:19 pm
