| Author |
Replies: 29,115 / Views: 1,217,088 |
|
|
|
Moderator
 United States
192314 Posts |
|
|
Bedrock of the Community
 United States
12887 Posts |
Nice, jbuck! 
|
|
Pillar of the Community
United States
531 Posts |
Acquired this at last week's MSNS Convention for my Civil War token exhibit. 
|
|
Moderator
 United States
192314 Posts |
Quote: Acquired this at last week's MSNS Convention for my Civil War token exhibit. Congratulations! 
|
|
Pillar of the Community
United States
531 Posts |
Thanks jbuck. Took me about 10 years to acquire enough of the varieties and another couple of years doing the biographical research for the write-up.
|
|
Moderator
 United States
192314 Posts |
Time well spent! 
|
|
Pillar of the Community
United States
1346 Posts |
For my type collection of Mexico I have for the most part avoided the Mexico new peso issues, they are as bad if not worse than Canada and the US for their milk barn emissions. But sometimes an opportunity presents itself... Undated - Pre-Columbian issue 1/4 oz, 1/2 oz and 1 oz in values of N$1, N$2 and N$5 of 1993. A couple are upside down, didn't have my glasses on when I took the pic :) .999 fine 
Edited by 999fine 04/17/2017 3:18 pm
|
|
Moderator
 United States
192314 Posts |
Very nice! 
|
|
Bedrock of the Community
United States
12057 Posts |
Member ANA - EAC - TNA - SSDC - CCT #890 "Most of the things worth doing in the world had been declared impossible before they were done." -- Louis D. Brandeis
|
|
Moderator
 United States
192314 Posts |
Wonderful additions, paralyse. 
|
|
Pillar of the Community
United States
1346 Posts |
An enjoyable eclectic selection
|
|
Pillar of the Community
United States
1346 Posts |
Your placement of staples gives me the willies.
|
|
Bedrock of the Community
United States
12057 Posts |
Have not scratched one in 20+ years. They are stored in binders so there is no contact and if I need to take one out of a 2X2 I use pliers to remove every staple first. Using the flat clinch stapler also helps.
Member ANA - EAC - TNA - SSDC - CCT #890 "Most of the things worth doing in the world had been declared impossible before they were done." -- Louis D. Brandeis
|
|
Pillar of the Community
United States
1346 Posts |
The pliers comment about removing staples scares me as well. Obviously you are well versed at handling your coins. I also get the willies at watching high-wire acrobats, but they, too know their craft :)
Great coins, nontheless. Jeff
|
|
Moderator
 United States
192314 Posts |
I usually up-size my holders, for example, dimes in cent holder, cents in nickel holders, etc. This gives some space around the coin where I can poke through the Mylar to get the coin out.
While my needing to remove a coin from one of my holders is rare, there are holders from coin dealers where I need to free coins to put into a Dansco album. My preferred method is using a pair of scissors to cut one side of the holder and release the coin. This works best when they only use three staples, but also well when they leave enough room between staple and coin.
I have had some where the staple was very close to the coin. Those times have been scary, for sure. I have even passed on a purchase seeing how close the staples are to the coin.
|
| |
Replies: 29,115 / Views: 1,217,088 |