Die polishing on that area. If they were lathe lines they would extend outwards on the die and be more stronger looking. As far as a doubled die, the devices are not enlarged. When we see notching, there should also be a widening of the devices that cause the notch, not just an intersection of the devices.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use