Found this 1957 LMC and was wondering if any one came across one with plating problems, it has a crack that runs from side to side through the CENT, thank you for any information
It looks like a planchet issue. The alloy mix may have been wrong causing this lamination error. It's not going to be very valuable because of the overall condition of the coin, but it is an error.
The mint didn't start plating cents until 1982. Before that the coins were Copper, Bronze or Brass, depending on the year that they were made.
Oh, yeah. They did mint a few million zinc plated steel cents in 1943. I almost forgot about those!
ANA ID: 3203813 - CONECA ID: N-5637 Clean a coin that may be worth collecting? Please DON'T! When in doubt, leave it dirty!!
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use