2020 Marsh-Billings Split Serrifs OBV & Rev

Note the affected areas are all on the outside edges of the devices. Nothing is enlarged. The common areas for a doubled die are not affected. So I'm leaning towards Machine Doubling as well. All the incuse devices are showing it, it only makes sense that all the raised devices have it as well. The lower central area above the date was a concern to me as to why it looks that way. But even using an inverted image on that area, is not showing what I wondered about. The devices must be very large?

Still looking at several images yet to see what is going on for sure on that one area?
No listings yet on the sites for a DDO or DDR. But I'm still thinking MD on both sides of the coin.



But the lower design I feel there is a relief around those letters:

Hard to tell from the images I can find so far on the sites.

Thank you @Coop. I know you guys are spot on. Like stated earlier if nothing else a great learning experience. Also would be a great teaching tool for you to make images of and references to in the future. I tell ya I love this hobby and all of the possibilities that come with it. And if this turns out to be Machine Doubling it is the nastiest and meanest ever!! Hahaha.

Try taking close up images to see if the devices are showing angled sides. All the images I've obtained doesn't show that, but I suspect that is what is going on with the devices above the date? If it looks like that on all sides of the devices. The reason I ask it that the tops of the devices look like Machine Doubling that pushed back that area?

Are these devices incuse on that area above the date, or raised?