| Author |
 Replies: 19 / Views: 2,660 |
|
Pillar of the Community
United States
6478 Posts |
I just found a stunning 1996 D LMC with  worthy lathe lines. Are there listings for these? |
|
|
|
Pillar of the Community
United States
740 Posts |
|
|
Pillar of the Community
 United States
6478 Posts |
Next time I see my dad I can take pictures. It is really nicely toned. Thanks for the link! Do these carry a premium? Edited by SilverStackerKid
07/25/2015 6:33 pm
|
|
Pillar of the Community
United States
7390 Posts |
Sweet! Cant wait to see it... Are you back in cali yet kid?
Edited by Cascade
07/25/2015 7:07 pm
|
|
Pillar of the Community
United States
1414 Posts |
SSK, there was another member that posted a Jefferson nickel with very nice Lathe lines a while back and I believe Ken Potter commented on it...you may look back and find it, I believe the stronger the Lathe lines the more premium... |
|
Pillar of the Community
United States
740 Posts |
I posted this nickel a month ago: https://goccf.com/t/233953I jumped on this topic for that reason. After finding out about lathe lines I knew the site where they were listed |
|
Pillar of the Community
United States
1414 Posts |
That's the one, thanks BlueSolo!
|
|
Bedrock of the Community
United States
62064 Posts |
|
|
Pillar of the Community
United States
6478 Posts |
Quote:
Are you back in cali yet kid? Leaving tomorrow. I will miss by dog and family for 10 months.  And thanks for the nickel link too. I was looking for it but forgot what it was called. |
|
Moderator
 United States
56855 Posts |
Waiting for pics  John1  |
|
Pillar of the Community
United States
6478 Posts |
Bad picture.   |
|
Pillar of the Community
United States
740 Posts |
Nice, have you identified which one it is on that website?
|
|
Pillar of the Community
United States
6478 Posts |
I have not because I just got back from Alabama. I will try to ID it now.
|
|
Pillar of the Community
United States
6478 Posts |
These are hard to attribute. It might be 15 or 16.
|
|
Moderator
United States
56855 Posts |
SSK, I know you know better then taking the pic with the coin IN the holder  I can barely see the lathe lines.There also seems to be a lot of dust or whatever in the 2x2,you need to make sure the 2x2 is clean inside before enclosing the coin.What I do is partially fold the 2x2 and flick it a few times with my finger to knock off the dust.Your coin seems to be in nice condition. John1 |
|
Pillar of the Community
United States
6478 Posts |
I was in hurry because my dad was about to leave and I only had a few seconds to take and send the pictures. The dust is actually on top of the holder. I was on an airplane and the the holder got dust from other holders on it. If that makes sense. Sorry about that.  Thanks for the advice though. |
| |
Replies: 19 / Views: 2,660 |
Posted 07/25/2015 5:41 pm
