I just looked at one I found today. Its in between the two images you posted. I don't think it is die wear as it usually affect the devices sides pointing to the rim and yours is the opposite edge of the device. But the metal appears pushed, so I'm thinking Machine Doubling. It is distorted on the higher side of the device but it is very minor. Again not a collectible, but not the result of hub doubling on the die.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use