Looks like a big struck through debris of some type. If it were PSD, then the coin would be bent and show though as raised on the opposite side. I see none of this going on from the image. So it is a Struck through error.
Large Strike through. Yet to see a lamination on a zinc cent. The zinc would be exposed if it did. Some say it doesn't happen because its not a typical alloy mix. Thanks, Doug.
Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited. Contact Us | Advertise Here | Privacy Policy / Terms of Use