| Author |
Replies: 11 / Views: 4,711 |
|
|
Pillar of the Community
United States
710 Posts |
Hi all, Found this is this a misaligned die error or an off-center strike? I know it is somewhat minor, but how much is the alignment off... what is the best way to determine that? Thanks!     
|
|
|
|
Bedrock of the Community
United States
62064 Posts |
Almost a collectable MAD coin. The reverse weakness is missing. Very close though. 
|
|
Moderator
 United States
34419 Posts |
@E4E, I think that in general MADs only have increased numismatic value if the coin is missing parts of the inscriptions or other design elements. Yours is pretty close and could merit a spot in a 2x2 as an exemplar. As to calculating the percentage of mis-alignment, I'm not sure.
"If you climb a good tree, you get a push." -----Ghanaian proverb
"The danger we all now face is distinguishing between what is authentic and what is performed." -----King Adz
|
|
Pillar of the Community
 United States
710 Posts |
Thanks for the input and the welcome!
Even with the wear and flatness on the date... the bottom of the 5 doesn't seem it ever made it on the planchet...
Since I am new I am happy with this find :)
Hey Coop... not sure exactly what you are meaning about the REV weakness, I should be looking for... Can you expand on that a bit? Or do you have a link you can direct me too to read more about it?
:)
|
|
Bedrock of the Community
United States
62064 Posts |
I'll have to put up an image later. I'm away from my computer now.
|
|
Bedrock of the Community
United States
74432 Posts |
Eye4Error, click on this link for Misaligned Die and look at the reverse side of the coin and you'll know what Coop means. There will be very helpful and very informative information on error-ref.com. I suggest you check out this link. http://www.error-ref.com/horizontal...-hammer-die/
Errers and Varietys.
|
|
Pillar of the Community
 United States
710 Posts |
Ok I see... thanks for the example! I did notice this on the REV... DIME is missing the top of the "ME" and the EPU is extra fat on the east side. Other than that a bit of mechanical error on some of the lettering...   
|
|
Valued Member
United States
150 Posts |
|
|
Bedrock of the Community
United States
62064 Posts |
 When the devices fall over the edge, the reverse shows weakness opposite the area where the die is not pressing during the strike: 
|
|
Pillar of the Community
 United States
710 Posts |
Thanks for clearing that up Coop... trying to gain some understanding here...  As for terminology... what kind of error is my dime?
|
|
Bedrock of the Community
United States
62064 Posts |
|
|
Pillar of the Community
 United States
710 Posts |
Thanks for all your help Coop! I am clear on this now! 
|
| |
Replies: 11 / Views: 4,711 |
|