| Author |
Replies: 12 / Views: 699 |
|
|
New Member
United States
1 Posts |
Edited by iq22002 07/01/2023 03:53 am
|
|
|
|
Moderator
 United States
15386 Posts |
 to the CCF If authentic that would be a 1981 Denver mint cent with two straight clips. There are diagnostics to distinguish a real clip (error) from one that occurred after striking (damaged coin) - I'm not an expert on that topic so I'll ask one of the moderators to move your post to a more appropriate forum where it can receive expert attention.
|
|
Moderator
 United States
56855 Posts |
 Need a bit higher quality pics and edge shots to be sure, but going with those pics it looks like PMD to me. John1 
|
|
Bedrock of the Community
United States
94367 Posts |
Angled closeups of the edges, please.  to the CCF!
|
|
Pillar of the Community
United States
4135 Posts |
Yes, as Coinfrog asked, the edge of coin will confirm what coin is. It is a must to see.
|
|
Moderator
 United States
56855 Posts |
Does no one read my posts?  John1 
|
|
Moderator
 United States
94728 Posts |
I have a huge issue seeing how a single cent can have 2 straight clips180 degrees opposite from each other - unless the material the blank was punched from was only .75% of a coin wide, which I highly doubt. Edit to add: (because John1 said it first) - PMD
Edited by Dearborn 07/01/2023 11:33 am
|
|
Moderator
 United States
94728 Posts |
Quote: Does no one read my posts? Did you have something to add to the conversation, John?  Yes I read it Quote:Need a bit higher quality pics and edge shots to be sure, but going with those pics it looks like PMD to me. and I agree - did you read my post just below yours?
|
|
Moderator
 United States
15386 Posts |
Quote: Does no one read my posts? Does John have anything to say about this one yet? Oh wait - that was John that no one read. 
Take a look at my other hobby ... http://www.jk-dk.art
|
|
Bedrock of the Community
United States
73628 Posts |
 To CCF! It's most likely PSD. We need close up pictures of the edge as the others stated.
Errers and Varietys.
|
|
Pillar of the Community
 United States
7174 Posts |
 to the CCF This is not posable as Dearborn explained. I have a shear at work that can make any amount of these you want. With a real straight clip, the letters would be falling off the edge, these are just cut. You might find 2 straight cuts, but they wouldn't be 180 degrees. And John1, I read all your posts 
|
|
Moderator
 United States
187582 Posts |
 to the Community!
|
|
Moderator
 United States
56855 Posts |
Cujohn  John1 
|
| |
Replies: 12 / Views: 699 |
|