Coin Community Family of Web Sites Join Thousands of Coin, Bullion, & Money Collectors
Royal Canadian Mint products, Canadian, Polish, American, and world coins and banknotes. Join Thousands of Coin, Bullion, & Money Collectors 300,000 items to help build your collection! Royal Estate Auctions - $1 Coin AuctionsVancouvers #1 Coin and Paper Money Dealer Specializing in Modern Numismatics Coin, Banknote and Medal Collectors's Online Mall








Username:
Password:
Save Password
Forgot your Password?


This page may contain links that result in small commissions to keep this free site up and running.

Welcome Guest! Registering and/or logging in will remove the anchor (bottom) ads. It's Free!

Are Slight M.a.d.'s Worth Keeping ?

To participate in the forum you must log in or register.
Author Previous TopicReplies: 6 / Views: 1,309Next Topic  
Pillar of the Community
eaglefoot's Avatar
United States
6326 Posts
 Posted 06/14/2016  9:49 pm Show Profile   Bookmark this topic Add eaglefoot to your friends list Get a Link to this Message Number of Subscribers
Common sense tells me that the more the exaggerated alignment, the better. But I'm wondering if the "slight" ones are worth keeping.
Because, if so, it seems like I could end up with a bucket full, and that tells me that they must be VERY common, hence, little value.
Is this correct then ? These slight M.A.D.'s are very common and most collectors don't save them ?
I began saving them, but stopped after like half a dozen Jeffersons and Lincolns. ..
Or should I be saving these ?
Edited by eaglefoot
06/14/2016 9:51 pm
Pillar of the Community
CoinMasters's Avatar
United States
5964 Posts
 Posted 06/14/2016  10:13 pm  Show Profile   Bookmark this reply Add CoinMasters to your friends list Get a Link to this Reply
They're more collectable when the devices start falling over the edge.
Pillar of the Community
Halo1st's Avatar
United States
2775 Posts
 Posted 06/14/2016  10:31 pm  Show Profile   Bookmark this reply Add Halo1st to your friends list Get a Link to this Reply
The common consensus here is if the misalignment is off enough to start dropping or cutting the devices off the edge, then the desirability goes up by collectors.

Minor ones seem to be pretty common at least on business strike cents.

There is always the Wow factor to consider. If it makes me go "what the heck?" I set aside for further scrutiny.

I remember using the guidelines above on a quarter about five years ago and set it free cause the devices were dead on the edge, but not missing. Later realized it possibly was more than just an alignment issue and wished I'd waited. Thanks, Doug.
Pillar of the Community
eaglefoot's Avatar
United States
6326 Posts
 Posted 06/14/2016  10:33 pm  Show Profile   Bookmark this reply Add eaglefoot to your friends list Get a Link to this Reply
Coinmasters"....
Yup...I know that, it's the others though that I'm trying to address.
Are these "slight" M.A.D.'s something I should just pitch back when I find them C.R.H. ?
Are they as common as I seem to be finding them ?

Halo....
Ahhh...ok, that's the answer I was looking for.
So the slight ones ARE common and should just be pitched back.
Edited by eaglefoot
06/14/2016 10:38 pm
Moderator
Learn More...
John1's Avatar
United States
56855 Posts
 Posted 06/15/2016  04:46 am  Show Profile   Bookmark this reply Add John1 to your friends list Get a Link to this Reply
Or you could save up a LOT and put them on the bay, 10 @ $ xxx
John1
Bedrock of the Community
coop's Avatar
United States
62064 Posts
 Posted 06/15/2016  09:36 am  Show Profile   Bookmark this reply Add coop to your friends list Get a Link to this Reply
The thing I've noticed on the collectable ones, is that were the offset happened there will be a weaker devices on that area.
Are-Slight-M.a.d.'s-Worth-Keeping-?
Note the weaker area on the reverse devices? If they show this then I would consider them collectable. I've seen examples where the weakness happened on the reverse, but the devices were not over the edge because of the location of the devices were not next to the rim. But this is rare, but I would call that a collectable one to save. The rest, put them back to work.
Keep in mind also that they position on the newer coins have reversed positions. Instead of the hammer being the obverse, the reverse is the hammer die:
Are-Slight-M.a.d.'s-Worth-Keeping-?
So you have to look at both sides to see if it is a MAD.

If both sides are off center, then it is an off center coin.
Bedrock of the Community
Conder101's Avatar
United States
17884 Posts
 Posted 06/15/2016  2:57 pm  Show Profile   Bookmark this reply Add Conder101 to your friends list Get a Link to this Reply

Quote:
If both sides are off center, then it is an off center coin.

Only if they are both off in the same direction to the same amount and part of the design is off the planchet. It IS possible to have misaligned dies on both sides of a coin. Many people think the anvil die can't be misaligned because it is contained within the collar. But it can be misaligned slightly resulting in a wide rim on one side and a very thin rim on the other. There is a MAD cent currently posted on the Cointalk forum with the obv die misaligned in one direction far enough that part of IGWT is off the planchet, and the reverse is also misaligned but in a different direction.
  Previous TopicReplies: 6 / Views: 1,309Next Topic  

To participate in the forum you must log in or register.



    




Disclaimer: While a tremendous amount of effort goes into ensuring the accuracy of the information contained in this site, Coin Community assumes no liability for errors. Copyright 2005 - 2026 Coin Community Family- all rights reserved worldwide. Use of any images or content on this website without prior written permission of Coin Community or the original lender is strictly prohibited.
Contact Us  |  Advertise Here  |  Privacy Policy / Terms of Use

Coin Community Forum © 2005 - 2026 Coin Community Forums
It took 0.22 seconds to rattle this change. Forums