| Author |
 Replies: 33 / Views: 22,248 |
|
|
|
Moderator
 United States
189340 Posts |
 to the Community! |
|
Bedrock of the Community
United States
74781 Posts |
Shawn1909, awesome find and congratulations! And thank you Tanman2001 for that link! I learned something new today.
Errers and Varietys.
|
|
Pillar of the Community
United States
5786 Posts |
Congratulations on a very nice find.
Words of encouragement are one of the major food groups.
We need to consume them regularly to thrive and grow.
|
|
New Member
 United States
10 Posts |
|
|
Bedrock of the Community
United States
62064 Posts |
 I doubt that is what really happened. It if it were a clash, then why are not all the devices present? If looks to me like a die was dropped on another die that left a contact mark that transferred to this die. There is not evidence if of a full clash present. The letters are partially over the edge of the die. So I question it at this time. |
|
Valued Member
United States
59 Posts |
"It looks to me like a die was dropped on another die that left a contact mark that transferred to this die."
Probably dropped and bounced, which accounts for the second letters. I suspect this happened during the annealing process, which is the only time the die would be soft enough to pick up details from such a relatively low-force impact.
Still a very cool variety, and not one I knew existed until ten minutes ago. Thanks for sharing and congrats to the OP on locating one in the wild.
Sean
|
|
Pillar of the Community
United States
1667 Posts |
I guess I'm just not at that level. I can't make sense of it. either the one in the article or the one here. I see the clash, looks like two clashes rotated fromt he coin device placement,
if it was a clash though, should be obverse design elements, but this looks like reverse die lettering not obverse.
Two reverse dies clashed a couple times together then they put a normal obverse/reverse set together with the clashed die to strike coins? I guess that's the mule?
|
|
New Member
United States
3 Posts |
The 1999 was my discovery coin
|
|
New Member
United States
3 Posts |
My discovery coin!  |
|
Bedrock of the Community
United States
62064 Posts |
I feel these were caused by dies dropped on top of each other. Before being struck or during a polishing issue. Note they are affect just certain areas of the design and not deep as a hub design would create. Some examples can be seen polished off on certain areas by die polishing:  Thus they may have tried to remove this die field disturbance. Seems to me to be just a die event. (die damage) More of a distraction rather than a variety. To me a mule die is a miss match of two different denominations on a strike by the die setup not being correct. Just a die event to me. |
|
Valued Member
United States
426 Posts |
That's awesome I remember what it was first found and discussed on a Facebook group I was in very cool die clash there
|
|
Moderator
United States
189340 Posts |
to the Community, Amy Antone! |
|
Pillar of the Community
United States
549 Posts |
|
|
Pillar of the Community
United States
2253 Posts |
Very nice find! I did not know this one existed. Will be keeping an eye out for it.
|
|
Pillar of the Community
 United States
8786 Posts |
|
| |
Replies: 33 / Views: 22,248 |
First Page
Posted 05/29/2019 12:31 pm
