| Author |
Replies: 16 / Views: 4,090 |
|
New Member
United States
11 Posts |
|
|
|
|
Bedrock of the Community
Australia
21786 Posts |
Correct weight should confirm, either way.
|
|
Moderator
 United States
56855 Posts |
 Weight? Should be 2.5 grams +/- .12 grams mint tolerance. Size? Should be 19mm.Please properly crop photos before posting and a little bit better focus. John1 
Edited by John1 12/21/2022 03:47 am
|
|
Pillar of the Community
 United States
6535 Posts |
|
|
Pillar of the Community
United States
1657 Posts |
Weight is important. Foreign planchet would not explain this though, when the planchet is struck it would still be the same size and thickness as a cent because it is being pressed into the dies by the strike. Most likely just some sort of damage.
|
|
Moderator
 United States
188213 Posts |
 to the Community! Your post was moved to the appropriate forum for the proper attention. 
|
|
Bedrock of the Community
United States
94367 Posts |
  to the CCF!
|
|
Bedrock of the Community
United States
19150 Posts |
I'm leaning toward post-strike damage.
|
|
Pillar of the Community
United States
616 Posts |
|
|
Pillar of the Community
United States
1648 Posts |
Quote: I may be wrong but I don't think the US Mint is still striking coins for foreign governments. The last one I can find was the Iceland 1000 Kroner in the year 2000. Struck on a foreign planchet can happen when a planchet intended for a foreign nation's coinage is struck by dies for a United States coin. As to your quote, yes this type of error was more common before 1984, when the U. S. Mint cut back its production of coins for other countries. What is less commonly known is that it still may occur as planchets are supplied to our mints at times by commercial vendors, and these vendors also service the mints of other countries. So it's not impossible for a shipment of planchets intended for one country to accidentally include those of another country. Even currently the Mint makes blanks for: Nickels, Dimes, Quarters, Half dollars, Dollars but for pennies, numismatic coins, and bullion coins, the Mint buys blanks. https://www.usmint.gov/learn/produc...n-production It is left to quality control as to whether this would be found commonly or rarely, or not at all imo. A smooth edge makes me think of a early state Dryer Coin. It also smashes and flattens the design of the coin over time so they look thicker and fatter. http://goccf.com/t/143863
Edited by datadragon 12/21/2022 3:45 pm
|
|
Moderator
 United States
95740 Posts |
looks like a Dryer Coin to me, I can see the zinc where the copper plating was worn off.
|
|
Pillar of the Community
 United States
7174 Posts |
 to the CCF and  just damage,
|
|
Bedrock of the Community
United States
10635 Posts |
Simply post mint damage. 
|
|
Pillar of the Community
Canada
6244 Posts |
What Data stipulate seem to be ok. I will verify this because I am not sure if was 2000 or 2001. In anyways, the US Mint do not done plated coins for foreign except if was not a wrong planchet but gone in the designated country.
|
|
Bedrock of the Community
Canada
24885 Posts |
 To the Forum.
|
|
New Member
 United States
11 Posts |
The weight on that 2015 shield penny was 2.41grams.
|
| |
Replies: 16 / Views: 4,090 |