| Author |
Replies: 24 / Views: 1,443 |
|
Pillar of the Community
 United States
1259 Posts |
|
|
|
|
Moderator
 United States
95432 Posts |
Edited by Dearborn 08/02/2023 7:43 pm
|
|
Pillar of the Community
  United States
1259 Posts |
Thanks Dearborn..when looked at thru the scope, it really stands out. Appreciate all of you at CCF.
|
|
Pillar of the Community
Canada
6244 Posts |
JFEED, it is DDR. Dear is right when stand of a combination of DDR and MD. Nice analyze You and Dear.
|
|
Pillar of the Community
  United States
1259 Posts |
Hey Silvio..Thanks for the encouraging comment. Got to admit that Dearborn is a pretty sharp guy, but don't tell him.
|
|
Bedrock of the Community
United States
73919 Posts |
|
|
Bedrock of the Community
United States
94367 Posts |
|
|
Pillar of the Community
Canada
6244 Posts |
Quote: Hey Silvio..Thanks for the encouraging comment. Got to admit that Dearborn is a pretty sharp guy, but don't tell him. OH NO, because after will trait me as a young puppy beginner. So do not worry I will keep silent and quiet. You know, me I am almost Senior but him it is an experiences senior.
|
|
Pillar of the Community
 United States
8740 Posts |
I have seen doubled dies with MD but do not think this is one of them. All I see here is MD and nothing more. To the OP, you have to make sure the mm location is the same when you are trying to match it with an attributed die, yours does not match DDR-011. The only time this may happen is when the opposing die to the doubled die has been changed out at some point.
-makecents-
|
|
Moderator
 United States
95432 Posts |
Quote: Got to admit that Dearborn is a pretty sharp guy, but don't tell him. don't worry, I'm not listening... 
|
|
Moderator
 United States
95432 Posts |
ya know, Jon is correct, your MM is closer to the 9 than the one on VV. so probably not DDR-011
Jon, I did consider that this was all MD, but most of it is almost level with the devices. The big spot I see strong MD in on the O of 'ONE'
|
|
Pillar of the Community
Canada
6244 Posts |
MAKE has a good point of the DDR-011 but this do not took out the DDR and the MD combination. VV it is full of mistakes and mix-up, but good references.
|
|
Pillar of the Community
  United States
1259 Posts |
I see nothing in the MM that would change my mind. I've looked at several websites that stated only one Mint had a mint marker and that was Denver. The sites also stated that the mint mark was hand punched until 1989 and that may be the reason the MM "appears" to be different that the Vista site might show. Actually. I Don't see the Dorrance, but I am not an expert
|
|
Pillar of the Community
  United States
1259 Posts |
|
|
Pillar of the Community
 United States
8740 Posts |
Here you go, jfeed, this is what I'm talking about. Yours is more upright, higher and more westerly. Hope this helps. 
-makecents-
|
|
Pillar of the Community
  United States
1259 Posts |
Thank you.. One question, please. With all due respect...Were the mint marks hand punched as stated on the websites?
|
| |
Replies: 24 / Views: 1,443 |